Super Fine High Purity Plaster of Paris
LUCKY MOUDLER STUCCO PLASTER is manufactured specifically for thin surface-finishing coat application on a wall that is leveled or plastered with sand and cement, to provide a very smooth but sturdy and durable surface. The plaster dries early, giving no room for abrasions or cracking, allowing you complete freedom to decorate the way you wish.
Unique properties
Easy to apply: Augmented with Calcium Sulphate Hemi Hydrate, the plaster is known for its great coverage ability, and is easy to work with.
Shrinkage-resistant, strong bonding: The plaster has a gradual setting time of 10 to 15 minutes
and attains full strength once set, without any shrinkage cracks.
Low density and higher coverage: Since it has low density, a 25kg bag of plaster can cover an area of approx. 26.5 sq. ft., when applied in 6mm thickness.
No water curing required: The plaster does not require curing after application, which helps save water and time.
High endurance level: The plaster makes for a
resilient but silky smooth surface that can withstand great impact.
Low thermal conductivity: Non-combustible, having very low thermal conductivity (K-Value), the plaster is made to protect the walls from thermal damage.
How to apply
LUCKY MOUDLER STUCCO is normally applied in 6mm thickness. It is very easy to mix and apply on the rigid surfaces like plastered walls.
Mark the wall vertically, with level strips, checked
with straight edge or line and level by using an aluminum square tube. Mark the highest spots with a minimum 3mm thickness to keep the overall thickness under control.
Wet the wall suitably, at least 10 minutes prior to the application so that all trapped air can be displaced to allow the plaster to attain good contact and strength with the wall.
While mixing, take care to add the plaster to the water and not the other way around. Use clean potable water to avoid contamination. Mix both to a workable consistency. Once ready, apply the mix to the walls according to the level strips markings.
For best results, apply a tight coat with firm pressure, using the trowel.
Plaster the entire surface in line and level it out. Once it starts to set, complete the application with a final stroke of the trowel.