Single Component Waterbased Acrylic Waterproof Coating

DESCRIPTION

Perma Eazee Coat SP is a milky white liquid which can be brush applied to most structural surfaces to make them waterproof.  The coating is UV stable and highly flexible.

PRIMARY USE

<div class="\" \\\\"pds\""="">

• Perma Eazee Coat - SP is used for waterproofing all types of RCC surface such as roofs, parapet walls and external walls. Asbestos cement sheet roof can also be waterproofed using scrim cloth or nylon mesh at the junction, overlaps and J – bolts as reinforcement.

• As a damp proof course applied under the first layer of bricks or blocks in masonry works.

• Because of the high quality of the product it can be used as final coat on many vertical surfaces after using a roller brush for the desired texture.

ADVANTAGES

• Perma Eazee Coat - SP is applied directly from the can.
• Eazee Coat - SP cures to give a permanently flexible and resilient smooth surface\\\\' resistant to a wide range of temperature.
• No cleaning solvents are required and it can be washed off with water when it is still wet.
• Single component and easily brush applied.
• Can be used on wet surface and during rainy seasons. Mechanical damages to the membrane can easily be repaired by spot application.
• The membrane allows the concrete surface to breath.
• Seamless application no joint are required.
• Can be applied with ease to a desired texture using a roller.

DIRECTION FOR USE

1.  WATERPROOFING NORMAL CONCRETE:

Clean the surface to remove all loose particles and any deleterious matter.  Repair all cracks, honeycombs and blemishes from the concrete surface.  Brush-apply Eazee Coat primer on the entire surface liberally.  Primer is prepared by diluting one part of volume of Eazee Coat with one volume of water.  When the primer coat is dry apply the second coat running the brush perpendicular to the first coat.  Provide fibre-glass or scrim fabric at junctions of vertical and horizontal surfaces after one coat then apply the second coat.

2.  ON ASBESTOS SHEET ROOFING:

Provide scrim or fibre-glass fabric at J bolts and junction of sheets over one coat of bitu coat and then brush apply Eazee Coat on the entire surface in two coats.

3.  DAMP PROOF COURSE:

On the cleaned plinth apply two coats of Eazee Coat.  The second coat applied after about four hours of the first coat.  When the second coat is still wet blind it with clean sharp sand to provide mechanical key.

NOTE:   Stir the material well in the container before use.

PROPERTIES