DESCRIPTION
Perma Anchor Fix – 80 is a polyester resin based grout which is used in locations where very high early and ultimate strengths are required along with chemical resistance properties. The Product is supplied in pre measured two component units.
PRIMARY USE
Anchor Fix – 80 is used for installation of dowel bars in concrete and for providing starter bars in RCC structures for continuation structural concrete or in extension of structural members. Anchor Fix-80 can be used for fixing foundation bolts, base plates and rail tracks. Because of its thixotropic nature the product is successfully used in vertical horizontal as well as in over-head applications.
DIRECTION FOR USE
PROPERTIES
Product | Two component |
Liquid | Strew coloured resinous liquid |
Powder | Free Flowing white powder |
Flash point of the liquid | 29 C |
Application temperature | 5 C to 40 C |
Service Temperature | -20 C to 60 C |
GEL TIME
AMBIENT | GEL TIME | MIN TIME |
TEMPERATURE | MINS | BEFORE LOADING |
C | ||
20 | 15 | 7 |
30 | 5 | 4 |
40 | 3 | 3 |
<div class="\\" pds"="">
COMPRESSIVE STRENGTH
IN 4 HOURS | 20 N/MM2 |
IN 24 HRS | 50 N/MM2 |
AFTER 7 DAYS | 90 N/MM2 |
TENSILE STRENGTH | 30 N/MM2 |
COVERAGE
Anchor Fix - 80 gives a paste of density 2.20. Hence one kg Anchor Fix gives a paste of 455 CC volume. The quanity of Anchor Fix - 80 required for anchoring various diameter bars in various diameter holes is as follows:
QTY ANCHOR FIX - 80 REQUIRED IN GMS FOR 100 MM BOND
Bolt Dia | 12 MM | 16MM | 20MM | 25MM | 32MM | 40MM |
Hole Dia | - | - | - | - | - | - |
20 MM | 44 | 25 | - | - | - | - |
25MM | 83 | 64 | - | - | - | - |
32 MM | 152 | 133 | 108 | 69 | - | - |
40 MM | - | 232 | 208 | 169 | 100 | - |
50 MM | - | - | 363 | 324 | 255 | 156 |
CHEMICAL RESISTANCE
Cured Anchor Fix 80 is resistant to fresh and saline water, petrol, diesel, oil, grease and most solvents, acids and alkalies.
ANCHOR DESIGN
Anchor Fix 80 is capable of holding heavy loads but the failure occurs in concrete, brick work, rock etc., in which the anchorage is provided. However loads which the Anchor Fix 80 withstands with 16mm anchor in 20mm dia hole, considering the general structural bodies in which anchorage are provided are as follows:
embedded | failure load |
length | tonnes |
100 | 3.5 |
200 | 8.5 |
400 | 18.0 |
600 | 30.0 |
NOTE:
A minimum factor of safety of 2 should be considered in all anchoring designs. Strength of the body in which the anchoring is provided should always be the guiding factor in anchor design. Above 60 C the Anchor Fix 80 start softening. Hence Anchor Fix 80 should not be utilized in places where temperatures are expected to rise over 60 C.
PACKING
Anchor Fix 80 is available in 250 gm and 1 kg packing apart from bulk on special request.
QUALITY ASSURANCE
Perma branded products when used in accordance with its current published directions for use performs as per its data sheets / catalogue. The manufacturer and the distributor will not be responsible for other materials and conditions of inferior workmanship.